แชร์หน้านี้ :

สอบถาม สั่งซื้อ

LINE @SoundDD.Shop

02-435-8998

FOCUSRITE RedNet D16R MkII Dante Audio Interface 16 ชาแนล AES3-RedNet Bridge, พร้อม Redundant Power Supplies

฿150,000 (รวม VAT 7% แล้ว)

เช็ค Stock และราคาสินค้า กับเจ้าหน้าที่ก่อนสั่งซื้อทุกครั้ง
รับสินค้าภายใน 3 - 7 วัน (ขึ้นอยู่กับที่อยู่จัดส่งของลูกค้า)

สงวนสิทธิ์การเปลี่ยนแปลงข้อมูล ราคา ไม่แจ้งให้ทราบล่วงหน้า
สงวนสิทธิ์การรับผิดชอบเนื่องจากการพิมพ์ผิดพลาดต่างๆ

แชร์หน้านี้ :

เช็ค Stock และราคาสินค้า กับเจ้าหน้าที่ก่อนสั่งซื้อทุกครั้ง
รับสินค้าภายใน 3 - 7 วัน (ขึ้นอยู่กับที่อยู่จัดส่งของลูกค้า)
สงวนสิทธิ์การเปลี่ยนแปลงข้อมูล ราคา ไม่แจ้งให้ทราบล่วงหน้า
สงวนสิทธิ์การรับผิดชอบเนื่องจากการพิมพ์ผิดพลาดต่างๆ

แชร์หน้านี้ :

Dante Audio Interface FOCUSRITE RedNet D16R MkII 16 ชาแนล AES3-RedNet Bridge, พร้อม Redundant Power Supplies จากแบรนด์ FOCUSRITE

FOCUSRITE RedNet D16R MkII
16-channel AES3-RedNet Bridge, with Redundant Power Supplies and Redundant Network Connections

16×16 AES3 I/O With Independent Level Control

The RedNet D16R MkII is a 16-channel bi-directional AES3 interface for Dante® networks. The 1U rackmount device features individual input and output channel level controls, allowing for precise calibration and control of all input and output levels using RedNet Control. RedNet D16R MkII features power supply and Ethernet redundancy with auto switchover in case of failure.

Various connection options make RedNet D16R MkII a flexible addition to any Audio-over-IP system. A pair of DB25 multipin connectors each connect eight channels of AES3 I/O into and out of the interface, while XLR and RCA ports enable two-channel AES3 and S/PDIF connections, respectively, to be made.

Sample rate conversion on every input enables external equipment to operate at different sample rates, and DARS signals are accepted on the XLR connector. Word Clock I/O on BNC connectors allows synchronisation to house clock, or syncing external equipment to the Dante network.

คุณสมบัติ

16-channel bi-directional AES3 interface for Dante networks
Individual input and output channel level control using RedNet Control software
Power supply and Ethernet redundancy with auto switchover in case of failure
Sample rate conversion on all input channels
Two DB25 connectors with AES59 standard configuration; each carries eight channels of AES3 I/O
RCA connectors for two-channel S/PDIF input and output
XLR connectors for alternate AES3 I/O and DARS input
BNC connectors for Word Clock input and output
Remote routing and control using RedNet Control and Dante Controller
Full operability with Focusrite RedNet and Red interfaces, plus all Dante devices from hundreds of manufacturers

น้ำหนัก	3.84 กก.
ขนาด	263 × 482.6 × 44.5 มิลลิเมตร
ยี่ห้อ	FOCUSRITE

สเปค

SPECIFICATIONS

INPUT / OUTPUT TRIM

Input Trim
-78 to 0dB in 1dB steps (per channel)

Output Trim
-78 to 0dB in 1dB steps (per channel)

INPUT SAMPLE RATE CONVERTORS

Sample Rate Range
32Hz to 214kHz

Gain Error
-0.3dB

Dynamic Range
Greater than 138dB (-60 dBFS method)

THD + N
Less than -130dB (0.00003%); 0 dBFS input

Latency
11 to 45 samples (network and input sample rate dependent)

DIGITAL PERFORMANCE

Supported Sample Rates
44.1 / 48 / 88.2 / 96 / 176.4 / 192 kHz (-4% / -0.1% / +0.1% / +4.167%) at 24 bit

Clock Sources
Internal, Word Clock, DARS, AES input 1-2, AES input 9-10 or from Dante Network Master

External Word Clock Range
Nominal sample rate ±7.5%

REAR PANEL CONNECTIVITY

AES/ EBU

Channel Count
2 x 2 S/PDIF Channels (reduces AES/EBU input channels)

Input And Output
2 x DB25 connectors (AES59 Combined I/O / Tascam Digital)

Alternate Input (Optional DARS)
1 x Female XLR (replaces DB25 channels 1-2)

Alternate Output
1 x Male XLR (duplicates DB25 channels 1-2)

S/PDIF

Channel Count
2 x 2 S/PDIF Channels (reduces AES/EBU input channels)

Input
1 x RCA phono socket (replaces DB25 channels 3-4)

Output
1 x RCA phono socket (switchable, duplicates any DB25 channel pair)

WORD CLOCK

Input
1 x BNC 75Ω port (switchable termination)

Output
1 x BNC 75Ω port

PSU & NETWORK CONNECTIONS

PSU
2 x Internal, 100-240V, 50/60Hz, consumption 30VA

Network
2 x EtherCON NE8FBH-S, also compatible with standard RJ45 connectors (Accomodates rugged EtherCON NE8MC*. Does not intermate with Cat 6 cable connector NE8MC6-MO and NKE65* cable)

FRONT PANEL INDICATORS

Primary PSU (A)
Green LED. Illuminates when an AC input is applied and all DC outputs are present

Secondary PSU (B)
Green LED. Illuminates when an AC input is applied and all DC outputs are present

Secondary Network
Green LED. Indicates that a network connection is present on secondary port when in redundant mode. Not used in switched mode

Network Locked
Green LED. When unit is following network grand master, shows valid network lock. When unit is network master, shows lock to indicated clock source. Flashing indicates external clock is selected but not connected

Sample Rate
Orange LED for each: 44.1kHz, 48kHz, x2, x4

Pull Up/Down
Orange LED. Indicates unit is set to operate on a Dante pull up/down domain

Signal Indicators
16 Green LEDs, 8 input/8 output indicators. Illuminate @ -126dBFS

Clock Source
Orange LED for each: Internal, Word Clock, DARS, Input 1–2 and Input 9–10

Primary Network
Green LED. Indicates that a network connection is present on primary port when in redundant mode. When in switched mode, a valid network connection at either primary or secondary network port will cause this LED to illuminate